Standalone plug & play wiring harness to run BMW 2.0(M47) and 3.0 (M57) diesel engines. Looms available for both types of ECU’s. Early 5 plug ECU’s known as DDE4’s found in the E46 and E39’s. Later 2 plug ECU’s known as DDE5/6 found in the E60 and X5’s etc.. The loom has the following. ECU plug which plugs directly into your BMW ecu and replaces the original bmw body loom. Choice of BMW or land rover Tdci/puma throttle pedal plug. OBD plug (for diagnostics). Its has output wires for an RPM gauge, an oil warning light for the dash as well as a Charge light for the dash. Compatible with auto and manual gearboxes (comes with canbus high and low wires for auto gearbox’s). Designed for use with a deimmobilised ecu which I can assist with too. Send me your ecu and I can remove the immo properly with software rather than the old method of fitting emulators which can fail leaving you stranded. Comes fully labelled up. The M57 is an increasingly popular engine swap. These looms allow you to run your M57 engine with minimal wiring and are designed to make your life easier when doing an M57 swap. You can have your engine up and running within minutes, on a pallet or in your conversion vehicle. Any questions give me a message thanks. Please state which loom & throttle plug you require on checkout, if unsure leave me a message or give me a call on 07432738429 thanks.
