Standalone plug & play wiring harness supplied with a brand new high pressure inline fuel pump. Looms available for both types of ECU’s. Early 5 plug ECU’s known as DDE4’s found in the E46 and E39’s. Later 2 plug ECU’s known as DDE5/6 found in the E60 and X5’s etc.. Compatible with both 2.0 (M47 and 3.0 M57) engines. The loom has the following. ECU plug which plugs directly into your BMW ecu and replaces the original BMW body loom. Choice of BMW or land rover Tdci/puma throttle pedal plug. OBD plug (for diagnostics). Fuel pump plug, roughly 9ft length of wire to allow for universal fitment. It has output wires for an RPM gauge and an oil warning light for the dash. Compatible with auto and manual gearboxes (comes with CANBUS high and low wires for auto gearbox’s). Designed for use with a de-immobilised ecu which I can assist with too. Comes fully labelled up. V’s, sprinters and even boats Etc… The M57 is an increasingly popular engine swap. These looms allow you to run your M57 engine with minimal wiring and are designed to make your life easier when doing an M57 swap. You can have your engine up and running within minutes, on a pallet or in your conversion vehicle. If your planning on using a standalone wiring loom then you’ll need the immobiliser (EWS) removing form your ecu. Once received ill remove the EWS properly via software rather than the old method of fitting emulators which can fail causing the EWS to re-arm. Once your ecu is done ill send it back with the loom. Any questions give me a message thanks. Please state which throttle plug you require on checkout, if unsure leave me a message or give me a call on 07432738429, if no message is left you will receive a loom with a BMW throttle pedal plug.
