FOR PREMIUM AMPLIFIED FACTORY SYSTEM RADIO REPLACEMENT. DOUBLE-DIN and SINGLE-DIN PROVISIONS INCLUDED (COMBO INCLUDES : DASH KIT and DATA BUS INTERFACE). This Item Is 100% BRAND NEW! Before you replace your factory radio with your new aftermarket radio, make sure you get the same parts a professional would use. Whether you’re installing an Alpine, Blaupunkt, Clarion, JVC, Kenwood, Panasonic, Pioneer, Sony, Valor or another stereo, you’ll want to get the right parts with the best fit and finish, get genuine Metra Products. Some “SELLERS” say they will send you what is “available” at the time. They substitute cheap, poor quality generic products for the Metra Harnesses and Antenna Adapters (when applicable). Wouldn’t you rather get what you paid for? Don’t fall for cheap substitutions that come in plain plastic bags, don’t fit right and should cost a lot less. This Complete Radio Install Kit comes with good instructions on removing the factory radio as well as installing your new one. Factory Sealed Packaging and 100% BRAND NEW! Recently many radio manufacturers started making Double Din Radios with 7 inch screens (some slightly smaller). These Double Din Radios are about 7 inches wide x 4 inches tall. Unfortunately this new size “DOES NOT” work with Metra Installation Kits without modifications. These kits have been manufactured for years before this new size radio became available. As far as we know, none of the aftermarket kit manufacturers are using this new sized opening at this time. The standard radio opening for this kit is approximately 6 7/8 inches x 3 7/8 inches or 173mm x 98mm. If you have one of these larger radios, you will need to SAND or FILE the opening to make it larger. Unfortunately at this time there are no other alternatives that we know of. (Additional Features and Item Specifics Below). DASH KIT and DATA BUS INTERFACE. DIN Radio Provision with Pocket. ISO DIN Radio Provision with Pocket. Double DIN Radio Provision. Stacked ISO Mount Units Provision. Retains Factory Climate Controls in Original Locations. Quick-Release, Snap-In ISO Mount System with Custom Trim Ring. Removable Oversized Storage Pocket with Built-In Radio Supports. Contoured and Textured to Match the Factory Dash. METRA DATA BUS INTERFACE. Designed to be used in vehicles that have the Rockford Fosgate audio system. The MITO-01 supplies a digital signal to turn the amplifier on. Also eliminates the “COM ERROR” message on the display when the OEM radio is removed. The radios speaker wires will provide the audio for the dash and rear speakers. The RCA’s will provide the audio to the amplifier to power the door speakers and woofer. (1) Metra Radio Housing 99-7010. (1) ISO Trim Plate. (2) Double DIN Brackets. (1) Double DIN Trim Plate. (1) Removable Storage Pocket. (1) Metra MITO-01 Interface. (1) 14-Pin Harness with RCA’s. (1) Factory Radio Side Harness. We provide our services as a courtesy for International Buyers (ANYONE OUTSIDE THE USA). We are a U. To research whether the part they are ordering will fit, work or is compatible, with their vehicle, before purchasing. The free listing tool. The item “99-7010 Car Stereo Single & Double-Din Radio Install Dash Kit for Eclipse with Amp” is in sale since Wednesday, June 13, 2012. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Interior\Dash Parts”. The seller is “honestdee” and is located in Seal Beach, California. This item can be shipped to United States, Canada, United Kingdom, Australia, Mexico, Germany, Japan, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Greece, Portugal, Cyprus, Slovenia, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Austria, Bahamas, Israel, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Dominican republic, Panama, Trinidad and tobago, Guatemala, El salvador, Honduras, Jamaica, Antigua and barbuda, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Saint lucia, Montserrat, Turks and caicos islands, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam.
- Interchange Part Number: 2-Din Aftermarket Trim Plate & Wiring Harness
- Color: Painted Silver
- Manufacturer Part Number: Metra 99-7010 + AXTO-MI1
- Special Notes: Compatible w/ Premium Amplified Systems Only
- Supported Radio Sizes: Double Din, 2 ISO Din Radios, Single Din w/ Pocket
- Product Type: Aftermarket Radio Car Stereo Installation Kit
- Radio Opening Dimensions: 6 x 3 Inches (173mm x 98mm)
- Radio Size Exclusions: DOES NOT Work With 7 x 4 IN (180mm x 100mm) Radios
- International Buyers (Outside U.S.A.): International Buyers (Outside U.S.A.)
- Placement on Vehicle: Front
- Other Part Number: Installation Mounting Panel & Wire Plug
- Brand: Metra 99-7010 D-Din CD Player DVD Adapter Bezel
