Performance Fuel Injection Systems Stand Alone Fuel Injection System WIRE HARNESS & ECM (computer). Putting together a TBI fuel injection on your Jeep 4.2l 258CI. If you have a doner 4.3L tbi and other. Off a TBI engine than this harness will help you out. Already have a LARGE CAP HEI DISTRIBUTOR? Comes with a Ignition control module and instructions to convert your HEI to a computer. Distributor so you have Spark and Fuel control on your Jeep. This is a fuel injection system Wire harness. Upgrading your carburated Classic Car, Truck, Jeep, Mud Bogger, OFF Road Truck, or Hot Rod to Fuel Injection and using a TBI Engine from a Truck Van then Performance Fuel Injection Systems has a harness for your project. Fuel injection is becoming a very popular upgrade. In a TBI Engine is nothing new. Fuel Injection Wire Harness from Performance Fuel Injection Systems is Just what you need. We eliminate what you don’t need. Our custom Chips in the ECM (computer) have what you don’t need turned off, so you wont get a bad running engine or a CHECK ENGINE LIGHT. Stand alone means that the system only needs 12 volt ignition and 12 volt battery feed to make the system run. We only use the 5 sensors so this is a very simple system, and the best of all the fuel injection system installed on your vehicle runs completely closed loop once warmed up (14.7 air fuel ratio) just like the new vehicles, but with fewer sensors than a new car. The TBI system is based off the reliable 1987 to 1995 Chevy PU with Throttle Body Injection (TBI) this was a proven great system for years and there were and still are thousands of these vehicles out there. The ECM are remanufactured. The wiring harness is all made with TXL wire which is water oil and grease resistance, and all in convoluted loom (split loom) which makes for a good looking system when you open the hood. Comes With Complete Instructions for installation. THIS HARNESS IS FOR A JEEP 258 4.2L TBI. Fuel Injection System Harness includes. Wiring Harness W/fuel pump relay and main power Relay. ECM (maybe re-manufactured) with custom calibrated EPROM chip (installed in ECM). 7 PIN IGNITION CONTROL MODULE W/INSTRUCTIONS TO CONVERT YOUR HEI DISTRIBUTOR. PFI STICKER FOR YOUR WINDOW, FENDER, UNDER YOUR HOOD, OR TOOL BOX. Lifetime on harness against defects 90 days for ECM. The item “JEEP 258 4.2L TBI Harness WithECM Fuel Injection Wire Harness WithINGITION MODULE” is in sale since Tuesday, April 25, 2017. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Air Intake & Fuel Delivery\Fuel Inject. Controls & Parts”. The seller is “performancefuelinjectionsystems” and is located in Elsie, Michigan. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, Sweden, South Korea, Indonesia, Taiwan, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Israel, Mexico, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, South africa.
- Brand: Performance Fuel Injection Systems
- Manufacturer Part Number: WHJ0001
- Warranty: Yes
- Country/Region of Manufacture: United States