Looking for the best in aesthetics, weight savings and reliability out of your harness? Our Pro Series harness completely replaces your old OEM harness so you can forget about those electrical gremlins. This Wiring Specialties PRO Series harness was designed from the ground-up to exceed OEM specifications for wire quality, power/ground routing. With our optimized and’tucked’ approach the end result will be a clean and worry free installation with a guaranteed start up. This Universal Harness is perfect for Race / Track cars, cars running a stripped interior / switch panel, or classic pre-EFI cars using the S13 SR20DET engine swap. It was developed in house on an actual S13 SR20DET engine to ensure a perfect fit to all engine connections. Wiring Specialties offers a number of options for common performance upgrades for this product. Build your perfect harness by selecting from the available options to the right, and as always – if you have any questions, please reach out to us. Race / Track cars, Cars running a stripped interior / switch panel, Classic & Pre-EFI cars, sand rails, dune buggies. Our Universal PRO harnesses are a perfect solution for the engine, and can come with an optional self-contained pre-wired fuse/relay block for ignition, cooling fans and fuel pump. If you plan on using your own relays and a switch panel, you do not need the fuse block. You just have to hook up start signal, fuel pump wires and a few other wires for tach and speedo, alternator warning light etc. Speedo and / or tach may need to have the signal adjusted using a frequency modulator (see Options to the right). You may have to run aftermarket gauges. Not compatible with mechanical cable driven speedometers. PRO-SERIES HARNESS TECHNICAL SPECS. Plug and Play simple and efficient. NO CORE HARNESS or additional wiring required. OEM wire colors used, where applicable. Fireproof fiberglass sleeving used in high-temp sections near the manifold & turbo (-40°C/-40°F to +450°C/+845°F operating temperature). Point-to-Point continuity tested on every wire. Constructed using exact OEM connectors and seals. Made with high temp TXL wire with adhesive shrink tubing (-40°C/-40°F to +125°C/+257°F operating temperature). Wrapped in lightweight nylon loom (-94°C/-137°F to +125°C/+257°F operating temperature). Includes a charge harness and improved grounds. Fully tested after production for an easy plug-and-play installation. Main Engine and Transmission one-piece tucked harness. MAFS connector (OEM or Upgraded). VTC connector (for S14 and S15 models). 4-pin and 5-pin ignitor chip connectors. OEM Oxygen sensor connector (wideband wiring is not part of the EFI harness and needs to be supplied). Idle control/fast idle connectors. Engine coolant sensor and gauge coolant temp switch. Speed sensor connector (Both S13 and S14 connectors are supplied). OEM oil pressure 1-pin connector (only 1-pin version supplied). Dash and fuse box connections through the Interface harness. Printable install instructions with pictures. Turn Key ENGINE START Guarantee. Type of Return Request. The item “Wiring Specialties Pro Engine Tranny Harness for S13 SR SR20 SR20DET Universal” is in sale since Wednesday, October 9, 2013. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Charging & Starting Systems\Other”. The seller is “autocat51″ and is located in West Covina, California. This item can be shipped worldwide.
- Manufacturer Part Number: WRS-PROS13SR20-UNI
- Brand: WSP
- California Prop 65 Warning: WARNING: The items in this ebay listing are found to have compounds and chemicals known to the State of California to cause cancer, birth defects, and reproductive harm:
